 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
13-5. TOP STEERING SHAFT REPAIR (CONT)
d. No. 2 Shaft Disassembly
NOTE
Foreign material must be removed
from shaft to remove bearing.
(1)
Remove three nuts (1), lockwashers (2),
washers (3), two retaining plates (4), center
flange mounting bearing (5), screws (6), and
upper shaft (7) from support bracket (8).
Discard lockwashers.
(2) Position shaft (7) in vise.
WARNING
Wear eye protection and use care
when removing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
Injury.
NOTE
Note position of yoke screw hole in
relation to groove in shaft splines for
proper assembly.
(3) Remove four retaining rings (9) from four
bearing caps (10).
CAUTION
Use care when removing bearing
caps. Bearings may fall out and be
damaged.
(4) Remove four bearing caps (10) and yokes (11
and 12) from U-joint (13).
13-16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
