No. 2 Shaft Assembly

TM 9-2320-360-20-2

e. No. 2 Shaft Assembly

(1)

Install yokes (1 and 2) on U-joint (3).

CAUTION

Use care when installing bearing

caps. Bearings may fall out and be

damaged.

(2) Install four bearing caps (4) through yokes (1

and 2) onto U-joint (3).

WARNING

Wear eye protection and use care

when Installing retaining rings.

Retaining rings are under spring

tension and can act as projectiles

when released causing severe eye

Injury.

(3) Install four retaining rings (5) on bearing caps

(4).

(4) Remove shaft (6) from vise.

(5) Install center flange mou nting bearing (7) and

two retaining plates (8) on support bracket (9)

with three screws (10), washers (11), new

lockwashers (12), and nuts (13).

f. Installation

(1)

Install support bracket (1) on firewall (2) with

two screws (3) and new locknuts (4) with aid of

assistant.

(2)

Install two remaining screws (5) and two new

locknuts (6) in support bracket (1).

(3) Install footrest (7) in cab floor (8).

(4) Push in two lockpins (9) to lock footrest (7) in

place.

(5) Push upper shaft (10) through base plate (1)

from inside cab.

13-17