No. 1 Shaft Assembly

TM 9-2320-360-20-2

c. No. 1 Shaft Assembly

(1)

Install dust cap (1) on shaft (2).

CAUTION

Both upper and lower yokes must be

in same position. Arrows on upper

and lower shafts must align. Failure

to comply may result in steering

shaft binding.

(2)

Install splined shaft (3) on shaft (2).

(3)

Install yokes (4 and 5) on U-joint (6).

CAUTION

Use care when installing bearing

caps. Bearings may fall out and be

damaged.

(4) Install four bearing caps (7) through yokes (4

and 5) onto U-joint (6).

WARNING

Wear eye protection and use care

when installing retaining rings.

Retaining rings are under spring

tension and can act as projectiles

when released causing severe eye

Injury.

(5) Install four retaining rings (8) on bearing caps

(7).

(6) Install four bearing caps (9) through yokes (10

and 11) onto U-joint (12).

(7) Install four retaining rings (13) on bearing caps

(9).

(8) Install grease fitting (14) in shaft (2).

(9) Remove shaft (2) from vise.

13-15