|
|
TM 9-2320-285-24-1
2-44. REAR AXLE MAINTENANCE (CONT)
b. Axle Shafts, Hubs, and Drums (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL/DISASSEMBLY (cont)
NOTE
Repeat steps 1 thru 3 above to remove and disassemble
right hand axle shaft, hub, and drum.
CLEANING
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in
a well ventilated area. Avoid contact with skin, eyes, and clothes
and don't breathe vapors. Do not use near open flame or
excessive heat and don't smoke when using it. Failure to do so
could cause serious injury. If you become dizzy while using
cleaning solvent, get fresh air and medical attention immediately.
If contact with skin or clothes is made, flush with large amounts
of water. If contact with eyes is made, wash eyes with water and
seek medical aid immediately.
Compressed air must not exceed 30 psi. Wear safety glasses
when drying parts with compressed air. Failure to do so could
cause serious injury to eyes and possible blindness. If you hurt
your eyes or if a foreign object is blown into your eyes, seek
medical attention immediately.
4
a. Bearing cones
Clean
Use cleaning solvent P-D-680.
(11 and 14)
Don't spin bearings with
compressed air
b. All other parts
Clean
Use cleaning solvent P-D-680;
dry with compressed air
INSPECTION
5
a. Bearing cones
Inspect
Replace if worn, chipped, or
(11 and 14)
nicked. If bearing is to be
replaced, replace mating
bearing cup (16 or 15). Dip
bearing cone in light oil
after inspection
2-515
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |