 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-1
2-44. REAR AXLE MAINTENANCE (CONT)
b. Axle Shafts, Hubs, and Drums (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL/DISASSEMBLY (cont)
1
b. Axle shaft (4)
Tap
Place 1-1/2 inch diameter
(cont)
brass drift against center
of axle shaft and strike
sharply with hammer to
loosen tapered sleeves (3)
c. Eight tapered
Remove
Pull from studs (18)
sleeves (3)
NOTE
Right and left axle shafts (4) are not interchangeable.
Mark end of axle shaft to aid installation.
d. Axle shaft (4)
Remove
Pull from housing
e. Gasket (5)
Remove and
From axle shaft (4) or hub
discard
(9)
2
Hub (9)
a. Nuts (6 and 8)
Remove
with locking
washer (7)
b. Hub (9) with
Remove
Do not let outer bearing cone
drum (10)
(11) fall
c. Outer cone (11)
Remove
From hub (9)
d. Oil seal (12)
Remove
From steel retainer (13)
e. Steel retainer
Remove
Drive out with brass drift
(13), inner
and hammer
cone (14),
and inner cup
(15)
f. Outer cup (16)
Remove
Drive out with brass drift
and hammer
NOTE
Do not remove studs (17 and 18) and brake drum (10)
from hub (9) unless replacement is required.
g. 10 studs (17)
Remove
Press out
h. Brake drum (10)
Separate
From hub (9)
i. Eight studs
Remove
Press from hub (9)
(18)
3
Axle hous-
Wear ring (19)
Remove
Use puller, only if replace-
ing end
ment is required
2-514
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals