|
|
TM 9-2320-285-24-1
2-41. TRANSMISSION MAINTENANCE (CONT)
g.
Gear Shift Control (cont).
(1) Gear Shift Control Lever and Cable (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (cont)
12
i.
Clamp (23)
Install
Around cable (27) and on
(cont)
screws (22)
j.
Two nuts (21)
Install and
tighten
k.
Tie strap (19)
Install
On cable (27) at location
noted during removal
l.
Protective hose
Install
At location noted during
(16) and
removal
three new tie
straps (15)
m.
Clamp (13) and
Install
Tighten nut (17)
nut (17)
n.
Connector
Connect
Push into wiring harness
housing (33)
connector
o.
Neutral start
Install
and backup
light
switches
p.
New tie strap
Install
On leads (49) at location
(20)
noted during removal
13
Left hand
a.
Cable (27)
Route
frame rail
b.
Two new tie
Install
At locations noted during
straps (14)
removal
c.
Heat shield
Install
14
Transmis-
a. Selector lever
Hold firmly
With pliers; be sure plier
sion, left
(6) shaft
jaws contact flat area of
hand side
shaft and not threaded
area; and be sure shaft is
in third detent position
(refer to step 1 above)
b. Selector lever
Install
On selector lever shaft
(6)
CAUTION
Be careful not to cross thread nut (5) in following step.
c.
Nut (5)
Start
On selector lever (6) shaft
2-460
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |