WINCH VALVES TO MOTORS HYDRAULIC LINES

TM9-2320-270-20-3

WINCH VALVES TO MOTORS HYDRAULIC LINES

This task covers:

a. Removal (page 4-1146)

b. Installation (page 4-1148)

INITIAL SETUP

Materials/Parts - Continued

Tools

Lockwashers, hose clamps (four required)

Wrench, open-end,

7/16-inch

Lockwashers, winch control panel

(two required)

(12 required)

Wrench, open-end,

1/2-inch

Packing, preformed, hose

Wrench, open-end,

5/8-inch

Tag, marking (item 18, appendix C)

Wrench, open-end,

1 1/2-inch

Wrench, open-end,

2-inch

Personnel Required

Materials/Parts

One

Hose plugs

Lockwashers, cover deck

(four required)

ACTION

ITEM

REMARKS

LOCATION

REMOVAL

NOTE

Tag hoses according to general maintenance instructions.

There are four sets of hoses. This procedure is for one set. Repeat for other three.

12 screws (2),

a. Using 1/2-inch wrench, unscrew and

1. Winch control

take off.

Iockwashers (3),

panel (1)

b. Get rid of Iockwashers (3).

and washers (4)

Take off.

Front cover

plate (5)

Four screws (7),

a. Using two 7/16-inch wrenches, unscrew

3. Cover deck (6)

lockwashers (8),

and take off.

and nuts (9)

b. Get rid of Iockwashers (8).

Lift off.

Cover deck (6)

4. Rear winch and

tire carrier

assembly (10)

4-1146