AUXILIARY TRANSMISSION TO TRANSFER CASE PROPELLER SHAFT

TM 9-2320-270-20-2

AUXILIARY TRANSMISSION TO TRANSFER CASE PROPELLER SHAFT

This task covers:

c. Installation (page 4-586)

a. Removal (page 4-584)

b. Cleaning/Inspection (page 4-586)

INITIAL SETUP

Tools Continued

Tools

Wrench, box, 15/16-inch

Bar, pry

Wrench, pipe, 18-inch

Woodblock

Punch, 3/32-inch

Materials/Parts

Hammer, hard plastic-face

Handle, ratchet, 1/2-inch drive

Lockwashers (eight required)

Pliers, slip-joint, angle-nose

Scriber, machinist's

Personnel Required

Socket, 5/8-inch, 1/2-inch drive

Socket, 15/16-inch, 1/2-inch drive

Two

Wrench, box, 7/16-inch

Wrench, torque, 1/2-inch drive

ACTION

REMARKS

ITEM

LOCATION

REMOVAL

NOTE

Jack one wheel on forward tandem axle off ground (TM 9-2320-270-10) to relieve any

windup.

Using hammer and punch, bend down four

Four lock plates (2)

Transfer case

tabs (3).

yoke (1)

Using 5/8-inch socket and handle, unscrew

Eight screws (5) and

Two bearing and cap

and take out.

four lock plates (2)

assemblies (4) to

transfer case

yoke (1)

Four bearing and cap

Using pliers, hammer and woodblock, drive

Transfer case

and pull out.

assemblies (4)

yoke (1)

It maybe necessary to rotate drive

shaft.

NOTE

Arrow marks are stamped on sleeve yoke and splined shaft. If arrow marks cannot be

seen, use scriber to mark sleeve yoke and splined shaft.

4-584