FUEL GAGE SENDING UNIT

TM 9-2320-270-20-1

BLACKOUT HEADLIGHT ASSEMBLY - CONTINUED

NOTE

FOLLOW-ON MAINTENANCE: Check operation (TM 9-2320-270-10).

TASK ENDS HERE

FUEL GAGE SENDING UNIT

This task covers:

b. Installation (page 4-392)

INITIAL SETUP

Materials/Parts

Tools

Cement, gasket (item 2, appendix C)

Knife, putty

Gasket

Screwdriver, cross-tip, number one

Lockwasher, sending unit to wire

Screwdriver, flat-tip, 3/16-inch

Equipment Condition

Battery disconnected (page 4-444).

ACTION

ITEM

REMARKS

LOCATION

WARNING

No open flames, welding, grinding, smoking, or use of heat producing devices

permitted near fuel tank and fuel lines during maintenance unless the fuel tank has been

cleaned and purged of all flammable liquids and vapors. Fuel burns easily and fumes are

explosive. Keep battery disconnected. Failure to observe these precautions could cause

serious injury.

REMOVAL

s. Using flat-tip screwdriver, unscrew and

Screw (3), lock-

1. Fuel gage wire (1)

take off.

washer (4), washer

to sending unit (2)

b. Get rid of Iockwasher (4).

(5) and fuel gage

wire (1)

Using cross-tip screwdriver, unscrew and

Screw (8) and ground

2. Ground wire (6) to

wire (6)

take off.

sending unit (2) and

fuel tank (7)

4-390