DOME LIGHT SWITCH AND WARNING LIGHT SWITCH

TM 9-2320-270-20-1

DOME LIGHT SWITCH AND WARNING LIGHT SWITCH

This task covers:

a. Removal (page 4-294)

b. Installation (page 4-295)

INITIAL SETUP

Personnel Required

Tools

Screwdriver, flat-tip, 1/4-inch

One

Wrench, box, 9/16-inch

Equipment Condition

Materials/Parts

Battery ground cable disconnected

Lockwasher, terminal screw

(page 4-444).

Instrument panel open (page 4-244).

(two required)

Tag, marking (item 18, appendix C)

ACTION

ITEM

REMARKS

LOCATION

REMOVAL

WARNING

Make sure battery ground cable is disconnected before doing this task. Failure to dis-

connect battery ground cable can cause personal injury and damage to electrical

system.

NOTE

Tag wires according to general maintenance instructions (page 4-1).

Steps in this task apply to both the dome light switch and beacon light switch except as

noted. Dome light switch is shown.

1. Terminal (1)

Screw (2), Iock-

a. Using screwdriver, unscrew and take

washer (3), and

off.

wire 094 (4)

b. Get rid of Iockwasher (3).

2. Terminal (5)

Screw (6) lock-

s. Using screwdriver, unscrew and take

washer (7), and

off.

wire 153 (8)

b. Get rid of Iockwasher (7).

Nut (11)

Using wrench, unscrew and take off.

3. Dome light switch

(9) to instrument

panel (10)

4-294