|
|
TM 9-2320-270-20-1
IGNITION SWITCH
This task covers:
a. Removal (page 4-246)
b. Installation (page 4-247)
INITIAL SETUP
Materials/Parts
Tools
Tag, marking (item 18, appendix C)
Pliers, slip-joint, angle-nose
Wrench, open-end, 3/8-inch
Equipment Condition
Personnel Required
Battery ground cable disconnected
One
ACTION
REMARKS
ITEM
LOCATION
WARNING
Make sure battery ground cable is disconnected before doing this task. Failure to
disconnect battery ground cable can cause personal injury and damage to electrical
system.
NOTE
Tag wires according to general maintenance instructions (page 4-1).
REMOVAL
Using pliers, unscrew and take off.
Nut (3)
1. ignition switch (1)
to instrument
panel (2)
Push in until wire terminals can be
ignition switch (1)
2.
accessed.
Using 3/8-inch wrench, unscrew and take
Nut (5) and
3. Terminal (4)
off.
wire 75 (6)
Using 3/8-inch wrench, unscrew and take
Nut (8) and
4. Terminal (7)
off.
wire 436 (9)
Using 3/8-inch wrench, unscrew and take
Nut (11) and
5. Terminal (10)
off.
wire 431 (12)
4-246
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |