REMOVAL - CONTINUED - TM-9-2320-269-34-10659

TM 9-2320-269-34-1

TRANSMISSION ASSEMBLY - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

REMOVAL - CONTINUED

29.

Transmission

Eight screws (2)

Using 9/16-inch socket and ratchet handle

assembly (1)

and washers (3)

with 1/2-inch drive, unscrew and take out.

30.

Flywheel housing (4)

Transmission (1)

a. Support the weight of the transmission

and gasket (5)

assembly (1) with transmission jack.

b. Using transmission jack, move trans-

mission (1) back to separate from

housing (4).

Keep transmission level until clear

of guide studs.

c. When clear of guide studs, tilt rear of

transmission (1) slightly downward, so

that torque converter will not fall out.

d. Lower transmission (1) and take out

from under vehicle.

e. Install torque converter restraining

strap.

f. Install assembly in overhaul stand.

g. Get rid of gasket (5).

INSTALLATION

WARNING

When the transmission is installed, the torque converter can slide forward out of the

transmission and fall. This can cause injury to you.

CAUTION

Maintain transmission alignment to engine flywheel housing during installation to

prevent damage to the converter.

31.

Flywheel

New gasket (5)

a. Remove dust plugs.

housing (4)

and transmission

b. Remove assembly from overhaul stand.

assembly (1)

c. Position the transmission on a trans-

mission jack.

d. Take off converter restraining strap.

e. Position transmission under vehicle

using transmission jack.

2-642