|
|
TM 9-2320-269-34-1
STOPLIGHT SWITCH WIRING HARNESS - CONTINUED
INSTALLATION - CONTINUED
NOTE
FOLLOW-ON MAINTENANCE:
1.
Connect battery cables (TM 9-2320-269-20-1).
2.
Install bottom seat (TM 9-2320-269-20).
3.
Check operation of vehicle stoplights (TM 9-2320-269-10).
TASK ENDS HERE
CONSOLE TACHOMETER AND OUTRIGGER HYDRAULIC SOLENOID WIRING HARNESS
This task covers:
a. Removal (page 2-573)
c. Inspection/Replacement (page 2-582)
b. Cleaning (page 2-582)
d. Installation (page 2-583)
INITIAL SETUP
Tools
Materials/Parts - Continued
Gun, soldering
Lockwasher, relay box center solenoid, left
Handle, ratchet, 3/8-inch drive
front terminal
Knife, pocket
Lockwasher, relay box center solenoid, right
Pliers, diagonal cutting
terminal
Screwdriver, flat-tip, 3/16-inch
Lockwasher, relay box top solenoid, left
Socket, 3/8-inch drive, 7/16-inch
terminal
Wrench, box-end, 318-inch
Lockwasher, relay box top solenoid, right
Wrench, box-end, 1/2-inch
terminal
Wrench, open-end, 3/8-inch
Rags, wiping (item 42, appendix B)
Wrench, open-end, 7/16-inch
Solder (item 46, appendix B)
Tag, marking (item 50, appendix B)
Materials/Parts
Tie, plastic (as needed)
Flux, rosin (item 18, appendix B)
Personnel Required
Gasket, outrigger warning switch
cover
Two
Gasket, outrigger, warning lockout
switch cover
Equipment Condition
Lockwasher, fuse block and light
brown wire
Outriggers down (TM 9-2320-269-10).
Lockwasher, throttle solenoid
Left side engine compartment hood open
Lockwasher, relay box bottom solenoid,
(TM 9-2320-260-10).
left terminal
Engine cover removed
Lockwasher, relay box bottom solenoid,
(TM 9-2320-269-20-1).
right terminal
Battery cables disconnected
Lockwasher, relay box bottom solenoid,
(TM 9-2320-269-20-1).
right front terminal
2-572
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |