|
|
TM 9-2320-269-34-1
GOVERNOR - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY/ADJUSTMENT- CONTINUED
93.
Control rack (1)
Spring ring (2),
a.
Put ring (2), spring (3), and seat (4)
governor spring (3),
on rack (1).
spring seat (4), and
b. Push seat (4) down, and put bolt (5)
bracket bolt (5)
through.
94.
Fuel injection
Gasket (7), governor
a. Put on part way.
pump (6)
housing (8), and six
b. Screw in screws (9) part way.
screws (9)
c. While assistant turns camshaft (10)
with drive flange holding wrench,
alternately tighten screws (9) using
3/8-inch flat-tip screwdriver bit, 3-
inch extension, and hinged handle with
1/2-inch drive.
95.
Governor housing (8)
Screw (11) and
Screw in, and tighten using 5/16-inch
washer (12)
flat-tip screwdriver.
96.
Six screws (9)
Stake in place using ball-p een hammer and
5/16-inch blunt-end punch.
97.
Bracket bolt (5)
Governor
Push seat (4) down, and put on.
bracket (13)
98.
Spacer (14), new
Using two 8-mm open-end wrenches,
lockwasher (15),
screw on and tighten.
and nut (16)
2-354
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |