CHAPTER 3 INSPECTION UPON RECEIPT - TM-9-1220-220-340042

TM 9-1220-220-34

CHAPTER 3

INSPECTION UPON RECEIPT

3-1.

SCOPE

This chapter gives procedures to check the M10 Series Ballistics Drive for faults you can see when it is received in the

DS/GS shop. It also tells you what part of this volume to go to for various repairs. A complete inspection should be made

and all faults listed on DA Form 2404 before taking any maintenance actions. The performance test in Volume I, Chapter

2, should be done after doing the inspection upon receipt.

3-2.

BALLISTICS DRIVE INSPECTION UPON RECEIPT

TOOLS:

1/4", 3/16" flat tip screwdriver

7/16", 1/2", 9/16", 3/4", 15/16", 1-1/16", 1-1/8" open end wrench

5/64" socket head screw key (Allen wrench or equivalent)

3/8" drive ratchet wrench

5/16" hexagon stud socket (3/8" drive)

6" extension (3/8" drive)

3/8" universal joint

0.075" to 0.085" adjustable face spanner wrenchs

SUPPLIES:

Paint (item 3, App A)

5/16" x 5/16" x 1" square stock.

PERSONNEL:

One

REFERENCES:

JPG 41C for completing DA Form 2404

TM 43-0139 for painting

TM 9-254 for general maintenance

EQUIPMENT CONDITION:

Ballistic drive mounted on vehicle, except for inspection items marked with an asterisk (*).

These items can be checked properly only with ballistics drive or subcomponents removed

from vehicle.

NOTE

Once the ballistics drive is removed from vehicle DS/GS does not have the tools to

accurately set the fire control level if the level is tampered with. If the fire control level

needs to be repaired, repair before removing ballistics drive from vehicle.

Para 3-1 Vol II

3-1