|
|
TM 5-6675-250-34
plunger
voids the water-tight charac-
t e r i s t i c s of the case.
a.
Removal
(2) Disconnect the interconnect and power
( 1 ) Verify that the MODE SELECT switch is
cables. Store the cables in the lid of the electronic
positioned to PWR OFF.
c o n t r o l unit case (fig. 2-92).
CAUTION
(3) If the hand lamp was used, disconnect from
When
placing
cables
in
the
electronic
the electronic control unit, and store with the cables.
control unit lid, care must be taken to avoid
( 4 ) Position the lid onto the bottom section of
cable contact with the plunger of the
t h e case and secure the latches.
pressure release valve. Disturbing the
the lower section of the case.
b . Installation.
(1) P r e s s t h e r e l i e f v a l v e o n t h e e l e c t r o n i c
( 3 ) Remove cable assemblies from the case as
required.
c o n t r o l unit case to relieve internal pressure.
(2) U n f a s t e n the latches that secure the lid to
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |