REPLACE SWIPE CARD READER

TM 5-6350-275-24&P

3-110. REPLACE SWIPE CARD READER. (Figure 3-58).

This task consists of:

a. Remove

b. Install

INITIAL SETUP:

Tools:

General Safety Instructions:

Tamper Proof Screwdriver (Item 41, App B)

Remove all jewelry while working on

Wire Strippers (Item 10, App. B)

equipment.

Wire Cutters (Item 24, App. B)

Materials/Parts:

Soldering Iron (Item 39, App. B)

Swipe Card Reader

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or

cables. Failure to do so may result in serious injury or death.

a. Removal

(1) Remove tamper proof screw(s) (2) from bottom of front cover (1).

(2) Press in on front panel assembly (1), slide panel up, and pull it away from bracket assembly (4).

(3) Tag, unsolder and remove wires from swipe card reader terminal board.

b. Installation

(1) Connect tagged wires and solder to swipe card reader terminal board.

(2) Align front panel (1), with bracket assembly (4), push in on panel assembly, and slide it down until locked into

position.

(3) Secure front panel assembly (1), using tamper proof screw(s) (2).

Figure 3-58. Removal and Replacement of Swipe Card Reader Assembly

3-206