REPLACE STARPIN KEYPAD ASSEMBLY

TM 5-6350-275-24&P

3-109. REPLACE STARPIN KEYPAD ASSEMBLY. (Figure 3-57).

This task consists of:

a. Remove

b. Install

INITIAL SETUP:

Tools:

General Safety Instructions:

Tamper Proof Screwdriver (Item 41, App B)

Remove all jewelry while working on

Materials/Parts:

equipment.

Starpin Keypad Assembly

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or

cables. Failure to do so may result in serious injury or death.

a. Removal

(1) Remove two tamper proof screws (2) from bottom of front panel assembly (1).

(2) Press in on front panel assembly (1), slide panel up, and pull it away from bracket assembly (4).

(3) Remove input terminal strip from PWA terminal board.

b. Installation

(1) Connect input terminal strip to PWA terminal board. (Ref. Appendix E, E-42)

(2) Align front panel assembly (1) and tamper proof spring (5) with bracket assembly (4). Push in on panel assembly

and slide it down until it is locked in position.

(3) Secure front panel assembly (1), using two tamper proof screws (2).

Figure 3-57. Removal and Replacement of Keypad Assembly

3-205