Figure 2-4. Receiver-mounting configuration

ME 6350-262-14/2/2-4

Figure 2-4. Receiver-mounting

configuration.

a.. Processor (fig. C-1). Prior to drilling holes in the

screws fastening the cover to the enclosure.

processor enclosure, temporarily remove the printed

(2) Remove and retain the seven 6-42x3/8 inch

circuit (pc) board to prevent accidental damage to it.

long screws fastening the pc board to the enclosure

Do not reinstall the pc board until the enclosure is

interior.

permantly secured to the mounting surfaces, and

(3) Using a number 18 drill, drill one or two (as

cables have been run through the conduit.

determined by the interconnection configuration)

(1) Remove and retain the two 6-32x3/8 inch long

pilot holes through the enclosure at the center-

2-8