CHAPTER 2 SERVICE UPON RECEIPT AND INSTALLATION

CHAPTER 2

SERVICE UPON RECEIPT AND INSTALLATION

Section I. SITE AND SHELTER REQUIREMENT

(1) The grid wire sensor should be stapled to the

2-1. Siting

barrier or to a smooth foundation board which is

a. The site of grid wire sensor will be installed so

then attached to the barrier.

that each circuit pair will protect a barrier having a

(2) The barriers should be so that any penetra-

nominal area of 10 feet by 12 feet. (Refer to

tion through the barrier in excess of a 4 inch square

paragraph 1-9.) External power is not required at the

area results in a break in one or more of the grid

installation site.

wires.

b. Factors which must be considered in locating the

2-2. Shelter Requirements

grid wire sensor at the site to assure it performs its

The nominal area required for the installed grid wire

designed function to the maximum practical extent

sensor is stated in paragraph 2-1.

are as follows:

Section Il. SERVICE UPON RECEIPT OF MATERIEL

see if shipment is complete. Report all discrepancies

2-3. Unpacking

in accordance with paragraph 1-2. The equipment

There are no special instructions for unpacking the

should be placed in service even though a minor

grid wire sensor from its shipping container. Observe

assembly or part that does not affect proper

the usual precautions and requirements associated

functioning is missing.

with handling precision electronics equipment.

c. Check to see whether the equipment has been

modified. (Equipment which has been modified will

2-4. Checking Unpacked Equipment

have the MWO number on the top cover.) Check also

to see whether all currently applicable MWO's have

a. Inspect the equipment for damage incurred

been applied. (Current MWO's applicable to the

during shipment. If the equipment has been dam-

equipment are listed in USASA PAM 310-6 or DA

aged, report the damage on DD Form 6 (para. 1-2).

PAM 310-7 as applicable.)

b. Check the equipment against the packing slip to

Section Ill. INSTALLATION INSTRUCTIONS

2-5. Tools, Test Equipment, and Materials

2-6. Installation Instructions

Required for Installation

a. Figure 2-1 and 2-2 shows pertinent dimensions

and spacing that must be maintained in placing,

Table 2-1 lists all tools and equipment required for

mounting and attaching the junction box and grid

wire to walls, floors, ceilings, doors and other

installation tools required for installation of the grid

barriers.

wire sensor.

2-1