|
|
Table 7-1. Direct Support Test Equipment.
Designation
Name
FSN
Common Name
AN/USM-210
6625-019-0815
VOM
AN/USM-281
6625-053-3112
PP-2309B/U
Power Supply, D-C
6130-752-2215
Power Supply
TK-105/G
Tool Kit
5180-610-8177
Tool Kit
AN/URM-127
Signal Generator
6625-783-5965
Audio Generator
Section III. TROUBLESHOOTING
7-5. Troubleshooting Data
the parts location information for the processor and the
transceiver.
a. General. In addition to the troubleshooting
chart, other troubleshooting data is supplied as
c. Schematic Diagrams. Figures FO-3 (located at
described in the following paragraphs.
rear of manual) and 7-1 comprise the schematic
diagrams for the processor and the transceiver
respectively.
Figure 7-1. Transceiver Schematic Diagram
7-6. Cable Checks.
between each lead and the conduit or each lead and its
respective shield. Continuity should indicate infinity.
The procedure outlined in a through d below is given as
c. Check for opens by selecting one conductor in
a convenient method for checking for continuity or a
short of single conductor and multiconductor cables.
the cable and grounding it at one end to the conduit. At
a. Disconnect both ends of the cable to be tested.
7-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |