|
|
TM 32-6110-003-24&P
(3) Remove 12 screws (1) from the filter-mounted side of the RFI filter assembly. Carefully lift RFI filter
assembly front plate (2) to obtain access to filter FL6 (92).
(4) Tag wires to filter FL6 for proper identification.
(5) Unsolder both wires to the filter, then remove the nut (92A) and lock washer (92B) that secure FL6
(92) to the front plate (2), then remove the filter FL6.
(6) To install a replacement FL6, secure it to the front plate with nut (92A) and lock washer (92B).
Solder both wires to FL6.
(7) Secure the front plate with 12 screws (1). Take care not to pinch wiring between cover and housing.
(8) Refer to figure 5-3. Replace RFI filter assembly (6) in accordance with paragraph 5-11a, and bottom
cover (3) in accordance with paragraph 5-11c.
(9) Refer to section V of this chapter.
h. Bus Bar E12, E13, and E14 Removal and Replacement.
Refer to figure 5-4 unless otherwise
indicated and proceed as follows:
(1) Refer to figure 5-3. Remove bottom cover (3) in accordance with paragraph 5-10a, then remove RFI
filter assembly (6) in accordance with paragraph 5-10c, steps (1) through (4).
(2) Remove 14 screws (96) that secure filter cover (78) to filter chassis.
(3) Remove screws (27) that secure terminal lugs (28) to bus bar being removed.
(4) Remove two flat-head screws (25) that secure the bus bar (26) to filter chassis (3). Remove bus bar.
(5) To replace bus bar (26), secure bus bar to filter chassis (3) with two flat-head screws (25). Secure
lugs (28) to bus bar with screw (27).
(6) Refer to figure 5-3. Install RFI filter assembly (6) in accordance with paragraph 5-11a and bottom
cover (3) in accordance with paragraph 5-11c.
(7) Refer to section V of this chapter.
i. Connector J9, J10, and J11 Removal and Replacement. Refer to 5-4 unless otherwise indicated and
proceed as follows:
(1) Refer to figure 5-3. Remove bottom cover (3) in accordance with paragraph 5-10a, then remove RFI
filter
5-27
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |