Connector A1P1 and J1 Removal and Replacement.

TM 32-5865-218-24&P

(4)

Replace connector bracket (66) in accordance with

paragraph 5-12u.

Refer to

ak. Connector A1P1 and J1 Removal and Replacement.

figure 5-14 and proceed as follows:

Remove screws in screw locking assembly holding connectors

(1)

A1P1 and J1 (figure 5-14, item 3) together and disconnect

Remove screw locking plates and replace, if

connectors.

damaged.

Tag wires on A1P1 (67), cut heatshrink, and desolder

(2)

Replace connector A1P1, if damaged.

wires.

Remove screw lock assembly on J1 (figure 5-13, item 68).

(3)

Replace screw lock assembly, if damaged. Tag wires on

Replace

J1, cut heatshrink, and desolder wires.

connector J1, if damaged.

al. Voltage Regulator A1 Terminal Stud E1 thru E8 Removal and

Refer to figure 5-13 and proceed as follows:

Replacement.

(1)

Remove voltage regulator A1 (16) in accordance with

paragraph 5-12h.

Tag and desolder all wiring connected to the terminal

(2)

stud(s) to be removed/replaced.

(3)

Remove terminals E3, E5, E6, or E7 by unscrewing terminal.

Remove terminals E1, E2, or E4 by unscrewing terminal and

(4)

removing washer (3).

Remove terminal E11 by first unscrewing and removing

(5)

terminal E6.

Remove terminal E9 or E10 by removing nut on screw holding

(6)

the terminal to VR1 or VR2.

Remove terminal E8 by removing screw, flat washer, and two

(7)

nylon sleeves that secure stud to voltage regulator A1,

then remove stud.

To replace terminal stud E8, secure it to voltage regula-

(8)

tor A1 with two nylon sleeves, flat washer, and-screw.

Solder wiring as tagged during removal.

(9)

(10) Replace voltage regulator A1 in accordance with paragraph

5-12h.

5-60