|
|
TM 32-5865-218-24&P
Refer to
Identification Plate Removal and Replacement.
ah.
Remove front panel (3) in accordance with paragraph
(1)
Remove two screws (69), lock washers (85), flat washers
(2)
(86) and nuts (87) that secure the identification plate
(88) to the front panel (3).
To replace, secure identification plate (88) to the front
(3)
panel (3) using two screws (69), lock washers (85), flat
washers (86) and nuts (87).
(4)
Replace front panel (3) in accordance with paragraph
ai.
Connector Bracket Electrical Contact Removal and Replacement.
Refer to figure 5-13 and proceed as follows:
(1)
Remove connector bracket (66) in accordance with paragraph
(2)
Cut and remove heatshrink from pin (78) to be replaced.
(3)
Tag and desolder wire(s) connected to electrical contact
(78).
(4)
Use extraction tool (Teradyne 600-0001-000) from the
solder side of the connector bracket to push the
electrical contact (78) through and out of the plate.
Use insertion tool (Teradyne 600-0004-000) to press the
(5)
new electrical contact (78) through and out of the plate.
Solder wire to electrical contact.
(6)
Slide a 1/2-inch piece of insulated heatshrink (App. D,
(7)
Item 12) over the contact and wire and heatshrink into
place.
Replace connector bracket (66) in accordance with
(8)
aj. Connector Bracket Polarizing Key Removal and Replacement.
Refer to figure 5-13 and proceed as follows:
(1)
Remove connector bracket (66) in accordance with paragraph
(2)
Push polarizing pin (79) out from electrical contact pin
(78) solder side of connector bracket (66).
(3)
Push in a replacement polarizing pin (79).
5-59
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |