Terminal Stud E1 Removal and Replacement.

TM 32-5865-218-24&P

Refer to section V of this chapter.

(6)

Refer to figure 5-9

and proceed as follows:

Remove enclosure (6) in accordance with paragraph 5-11a.

(1)

Remove screw (19), two nylon sleeves (20), flat washer

(2)

(21), and nut (22) that secure terminal stud E1 (18) to

connector panel.

Tag and unsolder all wiring to terminal stud.

(3)

To replace terminal stud E1, solder wires as tagged

(4)

during removal, then secure stud (18) to connector panel

(13) with screw (19), two nylon sleeves (20), flat washer

(21), and nut (22).

Replace enclosure (6) in accordance with paragraph 5-11,

(5)

step 1.

Refer to section V of this chapter.

(6)

h. Front Panel Removal and Replacement.

Refer to figure 5-9 and

proceed as follows:

Remove enclosure (6) in accordance with paragraph 5-11a.

(1)

(2)

Remove connector panel (13) in accordance with step (2)

of paragraph 5-11e.

Unscrew four standoffs (23) from front panel (10).

(3)

Remove EQPT-CSL control (7) in accordance with paragraph

(4)

5-11b.

Remove CREW CALL and RCDR ON switches (11) in accordance

(5)

with paragraph 5-11c.

Remove indicators (12) in accordance with paragraph

(6)

5-11d.

To replace front panel, install indicators (12) into

(7)

front panel in accordance with paragraphs 5-11d.

Install CREW CALL and RCDR ON switches (11) in accordance

(8)

with paragraph 5-11c.

Install EQPT-CSL control (7) in accordance with paragraph

(9)

5-11b.

(10) Secure four standoffs (23) to front panel (10), then

secure connector panel (13) to standoffs in accordance

with paragraph 5-11e.

5-34