REAR-REAR AXLE DIFFERENTIAL - CONTINUED
REMOVAL - CONTINUED
Lower bearing a.
Place wood block against yoke and
using ball-peen hammer, tap sharply
downward to force cap (2) out of
Using angle-nose slip-joint pliers,
carefully twist out cap (2).
Take hydraulic jack out from under
Tip cross and lower shaft (3) until
yoke (1) is free.
Twelve screws (5)
Place dolly-type jack
and lockwashers (6)
make sure jack is secure.
Using 15/16-inch socket and handle
with 1/2-inch drive, unscrew and take
Get rid of lockwashers (6).
Start two puller screws into holes
180 degrees apart.
Using adjustable wrench, screw in
puller screws until carrier (4) is free.
Using dolly-type jack, move
(4) and gasket (8)
away from housing (7).
Mount carrier (4) in overhaul stand
Get rid of gasket (8).