REAR-REAR AXLE DIFFERENTIAL - CONTINUED
INITIALSETUP - CONTINUED
Rear-rear axle differential drained
Tandem axle assembly removed (page 2-834).
Rear-rear axle shafts removed
Two lockplates (2)
Using ball-peen hammer and
and four screws (3)
drive-pin punch, flatten tabs.
Using 9/16-inch socket and ratchet
handle with 1/2-inch drive, unscrew
and take off.
Get rid of lockplates (2).
Place hydraulic jack under shaft (5)
near yoke and fit wood block in be-
Using hydraulic jack, raise shaft (5)
until cap (4) is forced out.
Using angle-nose slip-joint pliers,
carefully twist out cap (4).