TANDEM AXLE ASSEMBLY

TM 9-2320-269-34-1

Section X.

REAR AXLE

Page

Forward-Rear Axle Differential ........................

2-847

Power Divider Lockout Assembly ..............................

2-897

Forward-Rear Axle Housing .............................

2-844

Rear-Rear Axle Differential .........................................

2-908

Interaxle Differential .........................................

2-875

Rear-Rear Axle Housing .............................................

2-905

Intermediate Differential ..................................

2-887

Tandem Axle Assembly .............................................

2-834

TANDEM AXLE ASSEMBLY

This task covers:

a. Removal (page 2-835)

b. Installation (page 2-839)

INITIAL SETUP

Tools

Materials/Parts

Bar, pry, 24-inch

Pin, cotter, torque rod studs

Block, wood, 8-in. x 8-in. x 8-ft

(two required)

(as required)

Lockwasher, wheel sensor wire clips

Chocks, wheel

(six required)

Driftpin, brass, 3/4-inch

Hammer, ball-peen, machinist's

Personnel Required

Handle, ratchet, 3/4-inch drive

Hoist, overhead, 20-ton lifting

Two

capacity

Pliers, slip-joint, angle-nose

Equipment Condition

Socket, 3/4-inch drive, 1 5/16-inch

Socket, 3/4-inch drive, 1 11/16-inch

Rear axles drained (LO 9-2320-269-12).

Wrench, open-end, 7/16-inch

Air reservoir drained (TM 9-2320-269-20-1).

Wrench, open-end, 7/8-inch

Propeller shaft disconnected at interaxle

(two required)

differential (TM 9-2320-269-20-1).

Wrench, open-end, 1-inch

Wrench, open-end, 111/16-inch

Wrench, torque, 3/4-inch drive,

0 - 600 ft-lb capacity

2-834