 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM
9-2350-238-20-2
Remove
two
hexagon
head
capscrews
NOTE
11
The vehicle hydraulic system is
of
(32) and motor brake
selector
valve
the open center type and has
angle bracket (31).
pressure only when the hydraulic
pumps are operating.
Disconnect two tube assemblies (33) and
12
remove two preformed packings (34) and
1
Disconnect motor to shuttle valve metal
two tube nipples (35).
tube
assembly
(1)
from
traverse
brake
control shuttle valve (2) and lower
motor
13
Remove
eight
socket
head
capscrews
control line flange support (3).
(36) and two motor control line flange
supports (3 and 7).
2
Remove two tube nipples (4) and two
Remove
two
preformed
packings
(37)
preformed
packings
(5).
14
from two motor control line flange sup-
Disconnect motor to shuttle valve metal
3
ports (3 and 7).
tube
assembly
(6)
from
traverse
brake
Remove
hexagon
head
capscrew
(38),
control
shuttle valve (2) and upper
motor
15
control
line flange support (7).
hexagon plain nut (39), and Iockwasher
(40) securing loop clamp (41) to brake
hose clamp retaining strap (42).
4
Remove tube nipple (8), preformed pack-
ing (9), tube elbow (10), tube fitting
locknut (11), flat washer (12), and
Loosen hexagon head capscrew (43) and
16
remove
brake
hose
clamp
retaining
strap
preformed
packing
(13).
(42).
5
Disconnect cylinder traverse brake con-
trol line nonmetallic hose assembly (14)
from
brake
pipe
hose
swivel
joint
(15)
DISASSEMBLY
and traverse brake direct selector linear
valve (16).
Refer to page 2-73 for complete disassembly
of all hydraulic lines and fittings.
Remove
tube
reducer
(17),
preformed
6
packing (18), tube reducer
(19),
and
preformed packing (20).
INSPECTION/REPAIR
7
Remove
brake
pipe
hose
swivel
joint
1 Check
for
broken,
damaged,
or
missing
(15), preformed packing (21), and
parts.
traverse brake nonmetallic seal (22).
2 Repair
is
by
replacement
of
authorized
Remove traverse brake control shuttle
8
parts
(TM
9-2350-238-24P-2).
valve (2) from tube nipple (23).
Remove preformed packing (24), flat
9
REASSEMBLY
washer (25), tube fitting locknut (26),
tube nipple (23), and preformed packing
Refer to page 2-73 for complete reassembly
(27).
of all hydraulic lines and fittings.
10
Remove two hexagon plain nuts (28),
two Iockwashers (29), two hexagon
head capscrews (30), and traverse brake
direct
selector linear valve (16) from
motor
brake selector valve angle bracket
(31).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals