|
|
TM
9-2350-238-20-2
NOTE
6 Disconnect
brake
cylinder
to
selector
valve
The
vehicle
hydraulic
system
is
of
metal tube assembly (19) from boom and
winch and vehicle drum winch (13).
the open center type and has
pressure only when the hydraulic
pumps are operating.
7 Remove tube elbow (20), tube fitting
locknut (21), flat washer (22), and
1 Remove
eight
hexagon
head
capscrews
preformed packing (23).
(1), eight Iockwashers (2), and four split-
flange clamp halves (3) securing two
8 Disconnect
two
manifold
to
adapter
manifold to elbow tube assemblies (4 and
hydraulic cylinder metallic tubes (24) and
remove two preformed packings (25).
5) to manifold assembly counterbalance
(6).
2 Disconnect two manifold to elbow tube
DISASSEMBLY
assemblies (4 and 5) and remove two
preformed packings (7) from manifold
Refer to page 2-73 for complete disassembly
assembly counterbalance (6).
of all hydraulic lines and fittings.
3 Remove
eight
hexagon
head
capscrews
(8), eight Iockwashers (9), and four flange
INSPECTION/REPAIR
clamp halves (10) securing nipple to
winch motor tube assembly (11) and
1 Check
for
broken,
damaged,
or
missing
union to boom winch motor tube
parts.
assembly (12) to boom and winch and
vehicle drum winch (13).
2 Repair
is
by
replacement
of
authorized
parts
(TM
9-2350-238-24P-2).
4 Remove
two
preformed
packings
(14)
from nipple to winch tube assembly (11)
and union to boom winch motor tube
REASSEMBLY
assembly (12).
Refer
to
for
complete
reassembly
5 Remove hexagon head capscrew (15),
of all hydraulic lines and fittings.
Iockwasher (16), retaining lines to
bulkhead strap (17), and two cushioning
control clamp pads (18).
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |