|
|
TM 9-2350-238-20-1
5
Connect wiper motor switch electrical lead (8) to wiper motor and defroster lead disconnects
branched wiring harness (2).
Position defroster switch to defroster lead disconnect electrical lead (9) and wiper motor to
6
switch electrical lead (8) on windshield wiper motor (10), and secure with two new Iockwashers
(11) and machine screw (12).
7
Install machine screw (13), loop clamp (14), new Iockwasher (15), and new self-locking nut (16).
Connect circuit breaker to wiper motor and defroster electrical lead assembly (1) to toggle
8
switch (17).
9
Connect defroster switch to defroster lead disconnect electrical lead (9) to toggle switch (17).
10
Connect wiper motor to ground lead disconnect electrical lead (18) to wiper motor and defroster
lead disconnects branched wiring harness (2).
Position defroster switch to defroster lead disconnect electrical lead (9) and wiper motor to
11
ground lead disconnect electrical lead (18) on windshield, and secure with two machine screws
(20), two new Iockwashers (20), and two hexagon plain nuts (21).
Install three electrical tiedown straps (22).
12
2-198. MAINTENANCE OF CRANE OPERATOR'S ENCLOSURE KIT--ENCLOSURE.
This task covers: a. R e m o v a l
b. Inspection/Repair
c. Installation
INITIAL SETUP
Materials/Parts
Cotter pin (2)
Lockwasher (4)
Self-locking nut (11)
References
TM 9-2350-238-24P-1
Equipment Conditions
2-1126 Crane operator's enclosure kit electrical wiring removed
2-1129
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |