|
|
TM 9-2350-238-20-1
REMOVAL
Failure to remove or disconnect batteries before removing or installing any electrical
wiring harness or lead may result in injury or damaged equipment.
1 Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
clips, ground screws, etc. Remove only the hardware which secures the wiring harness or lead
being removed.
from oil reservoir heater assembly (4).
3 Remove six screws (5) and six packings with retainers (6) from oil reservoir heater assembly
(4).
4 Pull oil resewoir heater assembly (4) from hydraulic oil reservoir. Remove heater assembly
gasket (7).
5 Remove assembled washer screw (8), and disconnect cable terminal (9) of heating element to
slave electrical lead (3) from personnel vehicular heater.
2-1089
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |