|
|
TM 9-2350-238-20-1
2-182. MAINTENANCE OF HEATER INSTALLATION KIT--ELECTRICAL WIRING.
This task covers:
a. Removal of Battery Positive Terminal to Circuit Breaker Electrical Leads
b. Removal of Coolant Heater Circuit Breaker to Line Disconnect Special Cable Assembly
c. Removal of Bulkhead Disconnect circuit Breakers and Electrical Components Branched
Wiring harness
d. Removal of Bulkhead Dsconnects to Master Relay and Circuit Breaker Special Cable
Assembly
e. Removal of Heater Control Box to Driver's Heater Wiring Harness
f. Disassembly
g. Inspection/Repair
h. Reassembly
i. Installatiion of Heater Control Box to Driver's heater Wiring Harness
j.
Installation of Bulkhead dsconnects to Master Relay and Cicuit Breaker Special Cable
Assembly
k. Installation of Bulkhead Disconnect to Circuit Breakers and and Electrical components
Branched Wiring harness.
l. Installation of Coolant Heater Circuit Breaker to Line Disconnect Special Cable Assembly
m. Installation of Battery Positive Terminal to circuit Breaker Elecriical Leads
INITIAL SETUP
Materials/Parts
Gasket (2)
Electrical wire (figure D-2, appx D)
Lockwasher (4)
Lockwasher
References
TM 9-2350-238-24P-1
Equipment Conditions
2-640 Batteries disconnected
General Safety Instructionst
Failure to remove or disconnect batteries before removing or installing any
electrical lead or wiring harness may result in injury or damage to equipment.
2-1040
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |