|
|
TM 9-2350-238-20-1
2-155. MAINTENANCE OF LOCKOUT CYLINDER AND RELATED PARTS.
c. Installation
b. Inspection/Repair
a. R e m o v a l
This task covers:
INITIAL SETUP
NOTE
Tools and Special Tools
The following equipment condition
Automotive maintenance and repair shop
applies to the right side number 4
equipment: organizational maintenance,
lockout cylinder.
common no. 1 (less power) (item 80,
q Hammer
puller
Cab traversed to the left
(TM 9-2350-238-10)
Plier wire twister (item 30, appx G)
Sling (item 82, appx B)
NOTE
The following equipment conditions
Materials/Parts
apply to the left side number 2
Corrosion preventive sealant (item 35,
lockout cylinder.
Cotter pin (32)
2-952 Driver's seat removed
Hydraulic fluid (item 21, appx C)
2-840 Batteries removed
Lockwire (item 23, appx C)
2-840 Battery compartment tray removed
Masking tape (item 45, appx C)
Preformed packing (2)
General Safety Instructions
References
TM 9-2350-238-10
TM 9-2350-238-24 P-I
Removing plugs and compressing
cylinder may cause hydraulic fluid to
Personnel Required
spill. Wipe up any spilled hydraulic
Two
fluid.
Equipment Conditions
NOTE
The following equipment condition
applies to the right side number 1 and
number 2 lockout cylinders.
2-384 Powerplant removed
2-883
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |