MAINTENANCE OF AIR CLEANER BLOWER RELAY TO BULKHEAD DISCONNECT BRANCHED WIRING HARNESS.

TM 9-2350-238-20-1

Install slave receptacle connector (1) and four screws (2) in hull.

Install slave receptacle and ground electrical lead (3) in hull.

Untag and connect cable terminal (4) of slave receptacle and ground electrical lead to slave

receptacle connector (1).

Untag and connect cable terminal (5) of slave receptacle and ground electrical lead to hull.

Install voltage regulator to bulkhead disconnect, slave receptacle, and accessories panel special

cable assembly (6) in hull.

Untag and connect four shell connectors (7) to circuit breakers.

Connect cable terminal (8) of voltage regulator to bulkhead disconnect, slave receptacle, and

accessories panel special cable assembly to slave receptacle connector (1).

Connect plug connector (9) to voltage regulator.

Untag and connect receptacle connector (10), and install four washers (11) and four screws

(12) .

Untag and connect receptacle connector (13), and install four washers (14) and four screws

(15).

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-122. MAINTENANCE OF AIR CLEANER BLOWER RELAY TO BULKHEAD

DISCONNECT BRANCHED WIRING HARNESS.

d. Reassembly

This task covers:

a. Removal

b. Disassembly

e. Installation

c. Inspection/Repair

INITIAL SETUP

Materials/Parts

General Safety Instructions

Failure to remove or disconnect

References

TM 9-2350-238-24P-1

batteries before removing or installing

any electrical wiring harness or lead

may result in injury or damaged

Equipment Conditions

equipment.

2-640 Batteries disconnected

2-952 Driver's seat removed

2-739