MAINTENANCE OF VOLTAGE REGULATOR TO BULKHEAD DISCONNECT, SLAVE RECEPTACLE, AND ACCESSORIES PANEL SPECIAL CABLE ASSEMBLY; AND SLAVE RECEPTACLE AND GROUND ELECTRICAL LEAD.

TM 9-2350-238-20-1

For reassembly of wiring harness plug connectors, refer to general maintenance, page 2-371.

1 Install master relay to bulkhead disconnect electrical lead (3) to hull through driver's

compartment.

2 Untag and connect plug connector (2) to master relay.

3 Untag and connect plug connector (1) to bulkhead disconnect to batteries.

4 Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-121. MAINTENANCE OF VOLTAGE REGULATOR TO BULKHEAD DISCONNECT,

SLAVE RECEPTACLE, AND ACCESSORIES PANEL SPECIAL CABLE

ASSEMBLY; AND SLAVE RECEPTACLE AND GROUND ELECTRICAL LEAD.

d. Reassembly

a. Removal

This task covers:

e. Installation

b. Disassembly

c. Inspection/Repair

INITIAL SETUP

Materials/Parts

Electrical wire (figure D-2,

Electrical wire (figure D-2,

Electrical wire (figure D-2,

Electrical wire (figure D-2,

References

TM 9-2350-238-24P-1

Equipment Conditions

2-918 Hull access cover removed

2-840 Battery access cover open and all batteries removed

General Safety Instructions

Failure to remove or disconnect batteries before removing or installing any

electrical wiring harness or lead may result in injury or damaged equipment.

2-735