 |
|||
|
|
|||
|
Page Title:
MAINTENANCE OF LOW COOLANT WARNING LIGHT TO BULKHEAD DISCONNECT BRANCHED WIRING HARNESS. |
|
||
| ||||||||||
|
|
 TM 9-2350-238-20-1
4 Disconnect shell connector (4) from
6
Disconnect shell connector (6) from line
connection.
transmission oil thermostatic switch.
7
Remove aeration detector lead and diode
5 Remove aeration detector branched wiring
assembly (3) from powerplant.
harness (5) from powerplant.
Electrical wire is a manufactured item,
4
1 Inspect for broken, damaged, or missing
refer to appendix D.
parts.
Repair is by replacement of authorized
5
2 If damaged or missing, replace marker
parts (TM 9-2350-238-24 P-1).
bands. Etch or stamp lead number on
new band.
3 For repair of shell connectors, refer to
general maintenance, page 2-371.
5
Connect shell connector (2) to aeration
detector lead and diode assembly (3).
assembly (3) in powerplant.
Connect shell connector (1) to horn relay.
6
2 Connect shell connector (6) to line
connection.
Wiring harnesses and leads are secured to
7
the powerplant with loop clamps, straps,
3 Install aeration detector branched wiring
ground screws, etc. During installation,
harness (5) to powerplant.
make sure the wiring harness or lead is
secure and all hardware is tight.
4 Connect shell connector (4) to
transmission oil thermostatic switch.
2-119. MAINTENANCE OF LOW COOLANT WARNING LIGHT TO BULKHEAD
DISCONNECT BRANCHED WIRING HARNESS.
d. Reassembly
a. Removal
This task covers:
e. Installation
b. Disassembly
c. Inspection/Repair
INITIAL SETUP
General Safety Instructions
Materials/Parts
Electrical wire (figure D-2, appx D)
References
Failure to remove or disconnect
I
TM 9-2350 -238-24P-1
batteries before removing or installing
any electrical wiring harness or lead
Equipment Conditions
may result in injury or damaged
2-640 Batteries disconnected
equipment.
2-952 Driver's seat removed
2-731
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals