|
|
TM 9-2350-238-20-1
2-117. MAINTENANCE OF WARNING LIGHT LOW COOLANT DETECTOR TO
BULKHEAD DISCONNECT BRANCHED WIRING HARNESS (CONT).
3 Tag and disconnect two shell connectors
(3) from line disconnects to warning light.
Failure to remove or disconnect
4 Tag and disconnect shell connector (4)
batteries before removing or installing
from diode assembly and transmission
any electrical wiring harness or lead
temperature warning switch.
may result in injury or damaged
equipment.
5 Tag and disconnect three cable terminals
(5) from aeration detector.
1 Wiring harnesses and leads are secured to
the engine with loop clamps, straps, clips,
6 Tag and disconnect cable terminal (6) from
ground screws, etc. Remove only the
ground.
hardware which secures the wiring har-
ness or lead being removed.
7 Remove warning light low coolant detector
to bulkhead disconnect branched wiring
2 Remove two screws (1) and aeration
harness (7) from powerplant.
detection cover (2).
2-728
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |