 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2350-238-20-1
only the hardware which secures the
wiring harness or lead being removed.
Failure to remove or disconnect
Tag and disconnect six shell connectors
batteries before removing or installing
2
(1) from line connection on right discon-
any electrical wiring harness or lead
may result in injury or damaged
nect to headlamp wiring harness (2).
equipment.
Disconnect cable terminal (3) from ground
3
NOTE
on right disconnect to headlamp wiring
Procedures to remove disconnect to
harness (2).
headlamp wiring harness are written
for the right side, but apply to both the
4
Remove headless connectors base
right and left sides.
assembly (4) from hull.
1 Wiring harnesses and leads are secured to
Remove right disconnect to headlamp
5
wiring harness (2) from hull.
the hull and components with loop clamps,
straps, clips, ground screws, etc. Remove
DISASSEMBLY
1 Strip insulation (1) back from headless
5 Remove electrical insert (6) from threaded
connectors base assembly (2).
base (8).
NOTE
6 Remove rubber bushing (5) from threaded
The following steps are written for the
base (8).
removal of one electrical lead, but
apply to all electrical leads.
7 Remove nonmetallic seal (9) from
threaded base (8).
2 Remove electrical wire (3) and electrical
contact (4) from rubber bushing (5) and
8 Remove two machine screws (10), two
Iockwashers (11), and spring tension clip
electrical insert (6).
(12) from threaded base (8).
3 Remove electrical contact (4) from
electrical wire (3).
4 Remove rod (7) from electrical insert (6).
2-721
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals