|
|
TM 9-2350-238-20-1
INSTALLATION
4 Close air cleaner blower motor access
1 Install disconnect to forward air cleaner
door (1).
blower motor electrical lead (4) to hull
through driver's compartment.
5 Wiring harnesses and leads are secured to
the hull and components with loop clamps,
2 Untag and connect shell connector (3) to
straps, clips, ground screws, etc. During
line connection disconnect.
installation, make sure the wiring harness
or lead is secure and all hardware is tight.
3 Untag and connect shell connector (2) to
forward air cleaner centrifugal fan.
2-109. MAINTENANCE OF FUEL PURGE-AND-PRIME SWITCH TO SOLENOID
ELECTRICAL LEAD (ENGINE MODEL 7083-7395).
c. Installation
a. Removal
b.. Inspection/Repair
This task covers:
INITIAL SETUP
Materials/Parts
Electrical wire (figure D-2, appx D)
References
TM 9-2350-238-24P-1
Equipment Conditions
2-640 Batteries disconnected
2-952 Driver's seat removed
General Safety Instructions
Failure to remove or disconnect batteries before removing or installing any electrical
wiring harness or lead may result in injury or damaged equipment.
2-705
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |