INSPECTION/REPAIR - TM-9-2350-238-20-10695

TM 9-2350-238-20-1

DISASSEMBLY

For disassembly of wiring harness plug connector, refer to general maintenance, page 2-371.

INSPECTION/REPAIR

1 Inspect for broken, damaged, or missing parts.

2 If damaged or missing, replace marker bands. Etch or stamp lead number on new band.

3 For repair of cable terminal, refer to general maintenance, page 2-371.

4 Electrical wire and insulation sleeving are manufactured items, refer to appendix D.

5 Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

REASSEMBLY

For reassembly of wiring harness plug connector, refer to general maintenance, page 2-371.

INSTALLATION

Install bulkhead disconnect to generator

armature electrical lead (1) to hull.

Untag and connect cable terminal (2) to

generator armature, terminal B.

Connect plug connector (3) to voltage

regulator.

Wiring harnesses and leads are secured

to the hull and components with loop

clamps, straps, clips, ground screws, etc.

During installation, make sure the wiring

harness or lead is secure and all hardware

is tight.

2-669