INSPECTION/REPAIR - TM-9-2350-238-20-10689

TM 9-2350-238-20-1

INSPECTION/REPAIR

Rod and electrical wire are manufactured

1 Inspect for broken, damaged, or missing

items, refer to appendix D.

parts.

Repair is by replacement of authorized

2 If damaged or missing, replace marker

parts (TM 9-2350-238-24P-1).

bands. Etch or stamp lead number on

new band.

3 For repair of shell connectors, refer to

general maintenance, page 2-371.

For reassembly of wiring harness receptacle connector, refer to general maintenance, page 2-371.

INSTALLATION

4 Untag and connect seven shell connectors

Install line connection to right headlamp

(1) to line connections of right headlamp

disconnect branched wiring harness (6) to

disconnect branched wiring harness.

hull.

5 Wiring harnesses and leads are secured to

If removed, install new gasket (5) to

the hull and components with loop clamps,

receptacle connector (4).

straps, clips, ground screws, etc. During

installation, make sure the wiring harness

Connect receptacle connector (4) to light

or lead is secure and all hardware is tight.

harness connector and install four washers

(3) and four screws (2).

2-93. MAINTENANCE OF TRAILER RECEPTACLE ASSEMBLY TO DISCONNECT

BRANCHED WIRING HARNESS.

d. Reassembly

a. Removal

This task covers:

e. Installation

b. Disassembly

c. Inspection/Repair

INITIAL SETUP

General Safety Instructions

Materials/Parts

Electrical wire (figure D-2, appx D)

Rod (figure D-24, appx D)

Failure to remove or disconnect

References

batteries before removing or installing

TM 9-2350-238-24P-1

any electrical wiring harness or lead

may result in injury or damaged

Equipment Conditions

equipment.

2-640 Batteries disconnected

2-663