 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2350-238-20-1
INSPECTION/REPAIR
4 Electrical wire is a manufactured item,
1 Inspect for broken, damaged, or missing
refer to appendix D.
parts.
5 Repair is by replacement of authorized
2 If damaged or missing, replace marker
parts (TM 9-2350-238-24P-1).
bands. Etch or stamp lead number on
new band.
3 For repair of cable terminals and shell
connectors, refer to general maintenance,
INSTALLATION
5 Untag and connect shell connector (2) to
1 Install horn ground electrical lead (6) to
suspension lockout system warning light.
hull through driver's compartment.
6 Connect cable terminal (1) to driver's
2 Untag and connect shell connector (5) to
instrument panel ground.
horn.
7 Wiring harnesses and leads are secured to
3 Connect cable terminal (4) to horn ground.
the hull and components with loop clamps,
4 Install suspension lockout system warning
straps, clips, ground screws, etc. During
installation, make sure the wiring harness
light ground electrical lead (3) in hull
or lead is secure and all hardware is tight.
through driver's compartment.
2-92. MAINTENANCE OF LINE CONNECTION TO RIGHT HEADLAMP DISCONNECT
BRANCHED WIRING HARNESS.
d. Reassembly
This task covers:
a. Removal
b. Disassembly
e. Installation
c. lnspection/Repair
INITIAL SETUP
Materials/Parts
General Safety Instructions
Electrical wire (figure D-2, appx D)
Gasket
Rod (figure D-24, appx D)
Failure to remove or disconnect
batteries before removing or installing
References
TM 9-2350-238-24P-1
any electrical wiring harness or lead
may result in injury or damaged
Equipment Conditions
equipment.
2-640 Batteries disconnected
2-384 Powerplant removed
2-661
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals