|
|
TM 9-2350-238-20-1
2-56. MAINTENANCE OF THROTTLE AND ACCELERATOR CONTROLS AND LINKAGE
(ENGINE COMPARTMENT) (CONT).
REMOVAL (CONT)
Remove hexagon plain nut (36), Iockwasher (37), and hexagon head capscrew (38).
13
Disconnect rod assembly (39) from transmission and governor linkage bell crank (30).
Loosen hexagon plain nut (40). Remove rod end plain bearing (41).
14
Remove two cotter pins (42). Remove flat washer (43), helical spring (44), flat washer (45), and
15
threaded end rod (46) from transmission throttle control lever (47).
Remove transmission throttle control lever (47).
16
Remove hexagon plain nut (48), Iockwasher (49), and hexagon head capscrew (50).
17
Loosen two hexagon plain nuts (51 and 52). Remove rod end plain bearing (53) and hexagon
18
plain nut (51) from throttle linkage plain stud (54).
Remove hexagon plain nut (55), Iockwasher (56), and hexagon head capscrew (57).
19
Remove rod end plain bearing (58), hexagon plain nut (52), and throttle linkage plain stud (54).
20
Remove hexagon plain nut (59), Iockwasher (60), and hexagon head capscrew (61).
21
Remove two cotter pins (62) from headless straight pin (63). Remove headless straight pin and
22
throttle linkage bell crank (64).
2-502
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |