 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2350-238-20-1
11 Slide final drive coupling nut (21) onto
transmission shaft (19). Tighten coupling
nut, using drift and hammer or spanner
wrench.
12 Punch a dent in edge of final drive
coupling nut (21) about 1/32 in. (0.8 mm)
into two of four notches (22), using small
punch. Replace final drive coupling nut if
dents cannot be punched in undented sur-
face.
13 Install new seal (23) in groove in right
output drive cap (24). Trim seal (23) to
stick out 0.09 in. (2.30 mm) past mating
surface of right output drive cap (24).
2-405
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals