 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2350-238-20-1
Traverse cab (1) as far as it will go, either
left or right. Remove four plain cap nuts
(2) and hull transmission compartment
deck assembly (3). Remove four plain
cap nuts (4) and hull engine compartment
deck assembly lid (5). Remove two
hexagon head capscrews (6), two
lockwashers (7), and floor support beam
(8) from hull of vehicle.
Vehicle has no brakes when power-
plant is disconnected. Failure to
securely block front and rear vehicle
tracks could cause injury to personnel
or damage to vehicle or other
equipment if vehicle is free to roll out
of control.
2
Ensure that vehicle cannot roll out of
control. Block vehicle with 12 x 24 in. (30
x 61 cm) wood blocks placed under front
and rear of each track.
3
Set MASTER switch (9) to OFF position.
Place driver shift control latch (10) in N
(neutral), and pull parking brake handle
(11) to release parking brake.
4
Open battery access cover (12) and
remove battery protection liner (13).
Disconnect two electrical ground leads
(14) from storage batteries (15).
2-385
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals