|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Step 8.
Disconnect GND lead from driver's dome light. Place red probe in GND
lead. Ground black probe. Set MASTER switch ON. Set windshield
defroster switch ON. If multimeter indicates about 24 volts, windshield
defroster circuit is operating normally. If multimeter indicates no voltage,
repair GND lead between windshield defroster disconnect and driver's dome
light. Refer to page 2-371. Set MASTER switch OFF. Set windshield
defroster switch OFF. Connect lead.
2-354
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |