|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
To access wiring harness, remove hull engine compartment deck assembly
Step 7.
lid. Refer to page 2-935. Disconnect wiring harness. Place red probe in
socket B (lead 403 B). Ground black probe. Set MASTER switch ON. Set
fuel filter heater switch ON. If multimeter indicates about 24 volts, go to
step 8. If multimeter indicates no voltage, repair lead 403B between wiring
harness disconnect and fuel filter heater switch. Refer to page 2-371. Set
MASTER switch OFF. Set fuel filter heater switch OFF. Connect wiring
harness.
2-308
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |