|
|
TM 9-2350-283-20-1
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Disconnect lead 403B from fuel filter heater switch. Place red probe in lead
Step 6.
403B. Ground black probe. Set MASTER switch ON. Set fuel filter heater
switch ON. If multimeter indicates about 24 volts, go to step 7. If multim-
eter indicates no voltage, replace fuel filter heater switch. Refer to page
nect lead.
2-307
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |