|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Make sure MASTER switch is OFF before repairing electrical
circuits. Failure to observe this warning could result in injury to
personnel.
Remove lamp from HI BEAM IND light. Refer to page 2-571. Set MASTER
Step 1.
switch ON. Place blackout-infrared selection switch in infrared position and
infrared receiver switch in ON position. Press dimmer switch on floor.
Place instrument switch in ON position. Place red probe in socket. Ground
black probe. If multimeter indicates about 24 volts, replace lamp. If
multimeter indicates no voltage, set MASTER switch OFF, install lamp and
go to step 2.
Disconnect instrument (gage) panel wiring harness. Place red probe on
Step 2.
receptacle pin N (lead 519). Ground black probe. Set MASTER switch ON.
Turn vehicular light switch to SER DRIVE. Press headlamp dimmer switch
for high beam operation. If multimeter indicates about 24 volts, connect
wiring harness and go to step 4. If multimeter indicates no voltage, go to
step 3.
2-268
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |